1 ftr-k1 series n features l subminiature size l standard and high sensitivity types available l ul, csa recognized l fcc rules and regulations part 68 - dielectric strength 1,500 v between coil and contacts l high reliability-bifurcated contacts available l dil pitch terminals l plastic sealed type l rohs compliant. please see page 7 for more information note: for movable and stationary contact with gold overlay type, add suffx Coh. miniature relay 1 pole - 1 to 2 a (for signal switching) n partnumber information mz f - 12 w hg - k - u [example] (a) (b) (*) (c) (d) (e) (f) (g) mz series (a) relay type mz : mz series (b) dielectric funtion nil : standard type f : high dielectric strength type (c) coil rated voltage 12 : 1.5....48vdc coil rating table at page 3 (d) contact confguration nil : 1a single d : 2a single (without mzf) w : 1a bifurcated (e) coil type hg : standard type (without mz-d) (450-500mw) hs : high sensitive type (without mzf/mz-d) (190-270mw) (f) enclosure nil : flux free type k : plastic sealed type (g) ul, csa, standard nil : non ul, csa approved u : ul, csa approved non-promotional not for new designs
2 ftr-k1 series * minimum switching loads mentioned above are reference values. please perform the confrmation test with actual load before production since reference values may vary according to switching frequencies, environmental conditions and expected reliability levels. mz series n specification item standard type high sensitive type single bifurcated single bifurcated mz - ( ) d mz- ( ) hg mz-( ) whg mz - ( ) hs mz-( ) whs contact data confguration 1 form c (spdt) material gold-overlay silver nickel gold overlay silver-palladium resistance (initial) max. 100 m at 6 vdc, 1a contact rating (resistive) 2a, 24vdc 1a, 120vac 1a, 24vdc 0.5a, 120vac max. carrying current 2a max. switching voltage 120vac, 60vdc max. switching power 120va / 48wa 60av / 24w max. switching current 2a 1a min. switching load* 1ma, 1 vdc 0.1ma, 100 mvdc 1ma, 1vdc 0.1ma, 100 mvdc capacitance (at 10 mhz) approximately 0.8 pf (between open contacts, adjacent contacts) approximately 7.5 pf (between coil and contacts) life mechanical min. 20 x 10 6 operations electrical 1a, 120vac: min. 100 x 10 3 ops. 2a, 24vdc: min. 200 x 10 3 ops. min. 0.5a, 120vac: min. 200 x 10 3 operations 1a, 24vac: min. 500 x 10 3 operations coil data rated power 450 mw - 500 mw 190mw - 270 mw operate power 220 - 250 mw 100 mw - 130 mw operating temperature range -30 c to +55 c (no frost) 30 c to +75 c timing data operate (at nominal voltage) max. 6 ms release (at nominal voltage) max. 3 ms insulation resistance (initial) min. 1,000mohm at 500vdc dielectric strength open contacts standard: 500vac (50/60hz) 1min. high isolation: 1,000vac (50/60hz) 1min. contacts to coil standard: 500vac (50/60hz) 1min. high isolation: 1,500vac (50/60hz) 1min. surge strength coil to contacts 1,500v / 1 x 40s standard wave other vibration resistance misoperation 10 to 55hz double amplitude 3.28 mm endurance 10 to 55hz double amplitude 3.28 mm shock misoperation min. 100m/s2 (11 1ms) endurance min. 1,000m/s2 (6 1ms) weight approximately 3.5 g
3 ftr-k1 series n coil rating mz series coil code rated coil voltage (vdc) coil resistance +/- 10% (ohm) must operate voltage (vdc) * must release - voltage (vdc) * rated power (mw) 1.5 1.5 5 1.05 0.08 450 3 3 20 2.1 0.15 4.5 4.5 45 3.15 0.23 5 5 56 3.5 0.25 6 6 80 4.2 0.3 9 9 180 6.3 0.45 12 12 320 8.4 0.6 18 18 720 12.6 0.9 24 24 1,280 16.8 1.2 48 48 4,600 33.6 2.4 500 standard type high sensitive type coil code rated coil voltage (vdc) coil resistance +/- 10% (ohm) must operate voltage (vdc) * must release - voltage (vdc) * rated power (mw) 1.5 1.5 12 1.05 0.08 190 3 3 45 2.1 0.15 200 4.5 4.5 100 3.15 0.23 5 5 120 3.5 0.25 6 6 180 4.2 0.3 9 9 400 6.3 0.45 12 12 700 8.4 0.6 15 15 1,100 10.5 0.75 18 18 1,600 12.6 0.9 24 24 2,800 16.8 1.2 48 48 8,500 33.6 2.4 270 type compliance contact rating ul ul 508, ul 60950-1 e 45026 flammability: ul 94-v0 (plastics) [1a] 0.5a, 120vac (resistive) 1a, 24vdc (resistive) [2a] 1a, 120vac (resistive) 2a, 30vdc (resistive) csa c22.2 no. 14 lr 35579 n safety standards note: all values in the table are valid for 20c and zero contact current. * specifed operate values are valid for pulse wave voltage.
4 ftr-k1 series n characteristic data mz series n reference data
5 ftr-k1 series mz series
6 ftr-k1 series n dimensions mz series l dimensions mz (f) type (flux free type) l schematics (bottom view) l pc board mounting hole layout (bottom view) unit: mm mz (f)-k type (plastic sealed type)
7 ftr-k1 series 1. general information l all signal and power relays produced by fujitsu components are compliant with rohs directive 2002/95ec including amendments. l cadmium as used in electrical contacts is exempted from the rohs directives on october 21st, 2005. (amendment to directive 2 002/95/ec) l all of our signal and power relays are lead-free. please refer to lead-free status info for older date codes at: http://www .fujitsu.com/us/downloads/micro/fcai/relays/lead-free-letter.pdf l lead free solder plating on relay terminals is sn-3.0ag-0.5cu, unless otherwise specifed. this material has been ve rifed to be compatible with pbsn assembly process. 2. recommended lead free solder profle l recommended solder sn-3.0ag-0.5cu. rohs compliance and lead free information 3. moisture sensitivity l moisture sensitivity level standard is not applicable to electromechanical relays, unless otherwise indicated. 4. tin whiskers l dipped snagcu solder is known as presenting a low risk to tin whisker development. no considerable length whisker was found by our in house test. we highly recommend that you confrm your actual solder conditions flow solder condition: pre-heating: maximum 120?c soldering: dip within 5 sec. at 260?c solder bath solder by soldering iron: soldering iron temperature: maximum 360?c duration: maximum 3 sec. mz series
8 ftr-k1 series japan fujitsu component limited gotanda-chuo building 3-5, higashigotanda 2-chome, shinagawa-ku tokyo 141, japan tel: (81-3) 5449-7010 fax: (81-3) 5449-2626 email: promothq@ft.ed.fujitsu.com web: www.fcl.fujitsu.com north and south america fujitsu components america, inc. 250 e. caribbean drive sunnyvale, ca 94089 u.s.a. tel: (1-408) 745-4900 fax: (1-408) 745-4970 email: components@us.fujitsu.com web: http://us.fujitsu.com/components europe fujitsu components europe b.v. diamantlaan 25 2132 wv hoofddorp netherlands tel: (31-23) 5560910 fax: (31-23) 5560950 email: info@fceu.fujitsu.com web: emea.fujitsu.com/components/ asia pacifc fujitsu components asia ltd. 102e pasir panjang road #01-01 citilink warehouse complex singapore 118529 tel: (65) 6375-8560 fax: (65) 6273-3021 email: fcal@fcal.fujitsu.com web: http://www.fujitsu.com/sg/services/micro/components/ fujitsu components international headquarter offces ?2011 fujitsu components europe b.v. all rights reserved. all trademarks or registered trademarks are the property of their respective owners. the contents, data and information in this datasheet are provided by fujitsu component ltd. as a service only to its user and only for gen - eral information purposes. the use of the contents, data and information provided in this datasheet is at the users own risk. fujitsu has assembled this datasheet with care and will endeavor to keep the contents, data and information correct, accurate, comprehen - sive, complete and up to date. fujitsu components europe b.v. and affliated companies do however not accept any responsibility or liability on their behalf, nor on behalf of its employees, for any loss or damage, direct, indirect or consequential, with respect to this datasheet, its contents, data, and information and related graphics and the correctness, reliability, accuracy, comprehensiveness, usefulness, availability and completeness thereof. nor do fujitsu components europe b.v. and affliated companies accept on their behalf, nor on behalf of its employees, any responsibility or liability for any representation or warrant of any kind, express or implied, including warranties of any kind for merchantability or ftness for particular use, with respect to these datasheets, its contents, data, information and related graphics and the correctness, reliability, accuracy, comprehensiveness, usefulness, availability and completeness thereof. rev. march 02, 2011 mz series
|
